Condenser to stiffening and to front cross member. Condenser to front central stiffening and to support,bottom.

Hole plug for vacuum pump. 12 mm. Front left. 12 mm.

Ground cable to damper strut dome. Bracket.

Cable to terminal b+. Positive cable to battery.

Front fender to wheelhouse bracket. 4.8x13. Partition panel to fire wall,wheelhouse,connection support,and console. 4.8x13. Mounting, cover. 4.8x13. To 140 470 04 47. 4.8x13. Control unit. 4.8x13. Cooling pipe to side member and to engine cross member. 4.8x13. Line to upper rear wall. 4.8x13. High pressure line to subframe. 4.8x13. Screening below gear lever. 4.8x13. Heat shield mounting. 4.8x13.

Seal Ring

Pressure switch to liquid tank used for additional blower. 9.0 x 1.8 mm. Pressure switch to liquid tank used for compressor. 9.0 x 1.8 mm. At liquid tank. 9.0 x 1.8 mm. Refrigerant reservoir valve. 9.0 X 1.8 MM. Sensor. 9.0 x 1.8 mm.

From expansion valve to compressor.

Round-Sect. Sealing Ring

Pipeline. 17x2 mm.

To 129 830 01 70. To 140 830 20 15. Compressor-to-condenser refrigerant line.

Pipe line to shock absorber leg reinforcement.

Hexagon Head Bolt

Rear lid to hinge lever. Drive to rear pillar. Pipe line to shock absorber leg reinforcement. Strut to front cross member. Bracket to car floor. Cooling pipe to front cross member. Engine hood upper catch to engine hood. Partition panel. Strut to stiffening,front central.

Line to air conditioning system. 14X2 MMDiameter: 18mmStrength / hardness class: EPDMInside diameter: 14mmOutside diameter: 18mmMaterial thickness: 2mm. TUBING AT EXPANSION VALVE. 14X2 MMDiameter: 18mmStrength / hardness class: EPDMInside diameter: 14mmOut ...

Line to side member.

For fuel pipe and brake pipe. Fuel and brake lines to front support. Blinker-sender-to-toeboard/to-rightwheel-arch-panel main cable harness. Blow-off line to wheelhouse panel. Pressure-reservoir-to-connector hose to wheelhouse. Line to side member.

Heater. 7.5X2.0Strength / hardness class: EPDMInside diameter: 7,5mmOutside diameter: 11,5mmMaterial thickness: 2mm. HEATING. 7.5X2.0Strength / hardness class: EPDMInside diameter: 7,5mmOutside diameter: 11,5mmMaterial thickness: 2mm. MOUNTING PLATE TO DRI ...

Right.

Additional blower to front central stiffening. Front fender to wheelhouse. Bracket to cross member.

Additional blower to front central stiffening. Bracket to auxiliary fan.

Additional blower.