Battery, Starter/Alternator Cable for 1987 Mercedes-Benz 190E
Mercedes-Benz 100 ah. Secondary, with dual battry pkg. FILLED. 12V/100AH
Volt: 12V
Amps: 100AH
Gefahrgutkennzeichen: 8.1 Corrosive substances (batteries filled with acid).
Mercedes-Benz FILLED 12V/74AH. 12V/74AH
Volt: 12V
Amps: 74AH
Gefahrgutkennzeichen: 8.1 Corrosive substances (batteries filled with acid).
Mercedes-Benz End Pin Cap
Positive pole. Terminal post cap. Pole cover cap. Pole, starter and on-board ele. Sys. Battery.
Mercedes-Benz Nut
M8-10
Diameter: 8mm
Strength / hardness class: 10
Thread code letter: M
Thread pitch: 1,25mm
Width across flats: 13mm. Cable to starting motor,terminal 30. Horn to bracket.
Mercedes-Benz Cd changer to bracket. Mounting at console. Control module mounting.
Mercedes-Benz Covering to body. Control unit to the right of legroom. Covering to outside central piece. Starting cable to unit partition panel. 5 mm. Covering to cross member. For partition plate at wheel arch pan and reinforcement plate. See group 69,fig.no.: 53 see group 69,fig.no.: 56. Ashtray to tray. Switch to partition panel.
Mercedes-Benz Neg. Cable
From battery neg. Pole to ground 220 mm. Pole to side member.
Mercedes-Benz From side member to engine. From engine to frame. Frame to body. Motor to sliding sunroof segment. From cross member to engine.
Mercedes-Benz Main muffler suspension. M8x16. Central muffler suspension. Bracket on rear axle m 8x16.
Mercedes-Benz Reinforcement to support. Ground cable to frame side member. Torsion bar mounting. Bracket with license plate to front bumper.
Mercedes-Benz Wiper arm with blade to wiper spindle. Drive rod to crank arm. Wiper arm to wiper shaft. Wiper arm on spindle.
Mercedes-Benz 756. 1.0-2.5 mm2 ff6.3. Radio. 1.0-2.5 mm2 ff6.3. Engine hood. 1.0-2.5 mm2 ff6.3. Parking brake switch. 1.0-2.5 mm2 ff6.3.
Mercedes-Benz Amplifier at c-pillar. Amplifier to bracket. Reinforcem. At bracket, left.
Mercedes-Benz Cables to cable connector. At front center stiffening. Blinker & tempomat switches to steering column jacket tube. Cable to resistor. Main cable harness to radiator baffle, right. Starting cable to cable connector.
