Trunk Lining for 2026 Mercedes-Benz CLE53 AMG
Mercedes-Benz Lining to backrest frame
Diameter: 7,8mm. Cable duct on hinge lever
diameter: 7,8mm. Fastening, sidewall
diameter: 7,8mm. Left covering
diameter: 7,8mm. Right trunk lining
Diameter: 7,8mm. Bottom trunk sill
diameter: 7,8mm. Mount, right trim
Diameter: 7,8mm. Protective padding mount
Diameter: 7,8mm.
Mercedes-Benz Mount, left trim. Hinge cover mount to D-pillar. Upper center trim. Upper left. Mount, left cover.
Mercedes-Benz Trim to D-pillar. Lower part. Left cover mount to body-in-white.
Mercedes-Benz Holder, tie-down eye, trunk/load compartment
Diameter: 7mm
Inside diameter: 7mm
Outside diameter: 8,5mm. Load retainer
Diameter: 7mm
Inside diameter: 7mm
Outside diameter: 8,5mm. Rear anchoring lug
Diameter: 7mm
Inside diameter: 7mm
Outside diameter: 8,5mm. Tie-down eye, trunk/cargo area
Diameter: 7mm
Inside diameter: 7mm
Outside diameter: 8,5mm. Left and right
Diameter: 7mm
Inside diameter: 7mm
Outside diameter: 8,5mm.
Mercedes-Benz Rear floor liningDiameter: 8mmStrength / hardness class: 10.9Thread code letter: MThread pitch: 1,25mmWidth across flats: 14mm. Load retainerDiameter: 8mmStrength / hardness class: 10.9Thread code letter: MThread pitch: 1,25mmWidth across flats: 14mm. Moun ...
Mercedes-Benz Holder mount. Vehicle tool kit. Breakdown kit. Holder, tool box, trunk.
Mercedes-Benz In right trim. Switch, backrest release, rear seat, right, cargo area.
Mercedes-Benz In left trim. Switch, backrest release, rear seat, left, cargo area. Switch, backrest release, rear seat, right, cargo area.
Mercedes-Benz Rear lid to hinge lever. Drive to rear pillar. Pipe line to shock absorber leg reinforcement. Strut to front cross member. Bracket to car floor. Cooling pipe to front cross member. Engine hood upper catch to engine hood. Partition panel. Strut to stiffening,front central.
Mercedes-Benz Acceleration sensor to holder. M6X19
Diameter: 6mm
Strength / hardness class: 10.9
Thread code letter: M
Thread pitch: 1mm. Holder to left load compartment well. Holder mount. Support to left and right wheel well. Left mounting support to body-in-white. Holder to cockpit crossmember. Left sensor strip. Intake line to intake manifold.
