Suspension Subframe

Frame-type int. Support.

Axle Subframe Suspension

Front.

Bracket mounting
diameter: 3,2mm. Bracket to cross member
diameter: 3,2mm. Garnish moulding to front door edge
diameter: 3,2mm. Trim strip fastening
diameter: 3,2mm. LEFT
Diameter: 3,2mm. On rear panel
diameter: 3,2mm. Holder to holder
Diameter: 3,2mm. On wheelhouse bracket
diameter: 3,2mm. Screening plate to bracket
diameter: 3,2mm.

Right.

Right.

On upper left carrier. On carrier at top left. On left a-pillar. Mounting, luggage net. Thread, longitudinal member, front, left.

Hydropneumatic spring leg dome.

Frame-type int. Support. M14x1,5x147. Rear axle carrier to left front frame floor assembly. Chassis subframe mounting rear. Rear fastening.

Right.

Diameter: 10mm
Strength / hardness class: 10.9
Thread code letter: M
Thread pitch: 1,5mm
Width across flats: 16mm.

Steering to integral carrier, left.

Hex. Head Screw W Flange

Bracket to frame type integral support. M10x16.

Left.

Right.

Rear right.

Crossmember

Toeboard;left.

Outside right.

Outside bottom left.

Fuel lines to front partition panel. At floor.

Bracket to covering. Filler neck recess m 6x16. Bracket mounting m6x20. Headlamp wiper/washer.

Left.

Left wheelhouse. Cross member,left. At cross member. Left and right.

Left.

Right.

Left.

Ground connection. M8.

Ground connection. M8
Diameter: 8mm
Strength / hardness class: 8
Thread code letter: M
Thread pitch: 1,25mm
Outside diameter: 16mm
Width across flats: 13mm.

Repair solution for broken weld stud. (parts kit),line mounting. (parts kit) on left and right wheelhouses. Fuel and brake lines to main floor, left. Wheelhouse covering. Repair solution for ruptured welded pins menge nach bedarf.