Housing

Rear axle housing with differential, automatic five-speed transmission 1:2,82. 1:2.82. Rear axle center assembly with flange. 1:2.82.

Rear axle.

M24x1,5. Oil refilling. For oil drain and oil filler. For oil filler, transmission. (for oil drain and oil filling). (oil filling and oil drain at transmission). For filling in oil or draining off oil resp. At transmission for filling in oil up to transmission 6515822. For oil drain and oil tilling.

Differential Gear

Less ring gear and pinion. Without gear set.

As required 1,50 mm. 1.50 mm.

As required 1.35 mm.

As required 1.5mm. As required 1.50 mm.

As required 1,45 mm. 1.45 mm.

As required 1,55 mm. 1.55 mm.

As required 1,30 mm. 1.30 mm.

As required 1.40 mm. As required 1.4 mm.

As required 1.55 mm.

Used without automatic locking differential (asd).

1:2.82. 1:2.82.

Bolt

Ring gear to differential case. M12x22. Crown gear to differential housing.

Ring gear bearing. Differential gear. Right.

2.50 mm.

Spacer Washer

As required 1.1 mm. 1.10 mm.

As required 1.5mm. As required 1.50. 1.50 mm.

2.10 mm.

Bearing cover to axle housing. Clutch pressure plate to flywheel m8x22. Ring cylinder to rear axle housing m 8x12.

Axle shaft. Interior flange.

Inside.

As required 2.85 mm.

As required 2.75 mm.

As required 3.35 mm.

As required 3.05 mm.

As required 1.65 mm. 1.65 mm.

As required 1.90 mm. 1.90 mm.

As required 2.00 mm. 2.00 mm.

As required 2.10 mm. 2.10 mm.

As required 1.55 mm. 1.55 mm.

As required 1.85 mm. 1.85 mm.

Spacer Washer

As required 1.8mm. 1.80 mm. As required 1.85 mm.

As required 1.9 mm. 1.90 mm.

As required 1.6mm. 1.60 mm.

Spacer Washer

As required 2.0 mm. 2.00 mm.

Drive pinion bearing.

Bearing Sleeve

Drive pinion. Pinion bearing.

Drive pinion. Pinion bearing.

Drive pinion bearing. Outer bevel gear.

Drive pinion.

Joint flange 110mm. Propeller shaft 110mm.

Nut

M26X1.5
Diameter: 26mm
Strength / hardness class: ST
Thread code letter: M
Thread pitch: 1,5mm
Outside diameter: 38mm
Width across flats: 30mm. Joint flange to bevel gear. Screw fitting joint flange. Flange to drive pinion. Only used with asd.

End cover.

Hexalobular Screw

Diameter: 10mm
Strength / hardness class: 10.9
Thread code letter: M
Thread pitch: 1,5mm
Width across flats: 16mm.