Auxiliary heater;subsequent installation. Range of delivery.

Benzin thermo top c.

(type plate) webasto additional heater.

Resistor.

Breather line to activated charcoal filter. 10x6 mminside diameter: 10mmmaterial thickness: 0,6mm. BETWEEN FUEL LINE AND HEATER UNIT. 10X6 MMInside diameter: 10mmMaterial thickness: 0,6mm. HOSE TO FUEL PUMP. 10X6 MMInside diameter: 10mmMaterial thickness: ...

Circulation pump.

Circulation pump.

Tail lamp cable harness plug-connection,12-pole. Inboard/heater-operation cable-harness plug-connection.

BRACKET TO HEATER UNIT
Diameter: 70-90mm
Material thickness: 1mm
Width across flats: SW8. COLD-AIR SCOOP TO FENDER, RIGHT
Diameter: 70-90mm
Material thickness: 1mm
Width across flats: SW8. Refrigerant reservoir to wheel well
Diameter: 70-90mm
Material thickness: 1mm
Width across flats: SW8. FUEL FILTER
Diameter: 70-90mm
Material thickness: 1mm
Width across flats: SW8.

Hydraulic unit to bracket. Brake power regulator to bracket. Rubber bumper.

Thermostat.

Electric change-over valve. 40-50 mm. Cooling water hose to radiator. 40-50 mm. Cooling water pipe to side member. 40-50 mm. Cooling water hose to thermostat 40 - 50mm. 40-50 mm. Hose to radiator,thermostat,and water pump. 40-50 mm. From body to blower. 40-50 mm.

From thermostat to heater.

16-24mm.

From heater unit to thermostat.

Exhaust muffler. Heater unit. Heating.

Nut

M6. Bracket to water tank. Mounting parts. Control unit. Bracket mounting. Brake booster assembly to asr bracket. Fuel lines to cowl. Transistorized ignition switchgear to wheelhouse panel. Roller blind to rear panel covering, top.

Between heater unit and exhaust muffler 600 mm. Exhaust muffler 150mm. Exhaust guide from heater. Exhaust muffler 55mm. 370 mm. Between heater unit and exhaust muffler 470 mm. Between heater unit and exhaust muffler 520 mm.

Exhaust muffler.

Exhaust muffler. In front of muffler.

From heater unit to muffler. 24-26/ 16 mm. As required. 24-26/ 16 mm. Exhaust pipe to muffler. 24-26/ 16 mm.

Exhaust muffler.

Exhaust muffler.

Bracket mounting. Breather fastening to firewall. Appartus case at fire wall. Vacuum line to fire wall.

Air conditioner housing to mounting console
Diameter: 6mm
Strength / hardness class: 10.9
Thread code letter: M
Thread pitch: 1mm. CLAMP TO BRACKET
Diameter: 6mm
Strength / hardness class: 10.9
Thread code letter: M
Thread pitch: 1mm. AIR CONDITIONER CASE TO CONSOLE
Diameter: 6mm
Strength / hardness class: 10.9
Thread code letter: M
Thread pitch: 1mm.

St4.8x9.5.

Fuel-oil pump. Independent heating. Metering pump.

Fuel-oil pump. Fuel pump on cross member.

Fastening, fuel hose to plastic line. 8 mm. Between fuel line and heater unit. 8 mm. Feed and return lines, breathing. 8 mm. Fuel line to floor,right. 8 mm. From fuel pump to fuel line. 8 mm. Fuel line leading to heater unit. 8 mm.

From intermediate piece to heater unit.

(feed line),from fuel-oil pump to intermediate piece.

Brake line to fire wall. Fuel line under main floor. Air conduits to front subframe. For fuel pipe and brake line. Lines to frame. Fuel lines on main floor,left. Brake line to side member. For fuel pipe and brake pipe up to chassis 7519994.

Activated charcoal filter. Line to cross member. Breather line to wheel arch 8 / 3,2 x 12 mm. De-aeration line 8 / 3,2 x 13 mm. Regeneration line. From return line to fuel tank.

Brake line to fire wall. Right front brake line to left top connection support. Fuel lines to vehicle floor. Main cable harness to fire wall. Brake line to cross member. Breather hose to rear axle cross member. Brake line to side member. Fuel line to side member. Fuel lines on floor under rear seat.

Heat duct to front longitudinal memb. Chafe protection
Inside diameter: 3mm
Outside diameter: 8mm. FUEL LINE
Inside diameter: 3mm
Outside diameter: 8mm.

Hose to suction line.

Bowden cable to heating feed hose. Compressor-to-condenser refrigerant line to side member. Oil pressure gauge line to speedometer drive shaft. Sensor cable 8 mm.

At left side member.

From pipe line to heater unit.

From pipe line to check valve.

From check valve to standard heater and to by-pass.

From thermostat to pipe line.

From heater unit to pipe line.

Check valve.

Behind unit separation panel.

Panelling to fender.

From timing valve to by-pass.