In air inlet covering,used for windshield wiper setting opening.

In floor,above rear rear axle d=26 mm. For cover plate. In rear end floor.

In fire wall, right bottom. 42 mm. Passage holes in rear pillars,inside. 42 mm. Summer ventilation. 42 mm. Opening in partition panel,left d=42,0 mm. 42 mm. Outer left rear rear-end floor. 42 MM.

To plug the oblong holes in side members. Rear wheelhouse,outside 32 mm. To plug the hole in front side member end piece. Rear inside left wheelhouse 32 mm. Front and rear side member coverings d=32,5 mm. Rear wheelhouse,inside d=32.0 mm. Wheelhouse, rear left, exterior 32 mm.

To plug oval holes used for central locking mechanism & window regulator.

(to plug drain holes in side member shells).

Insulation mounting. 8.5 mm. Rear seat framework. 8.5 mm. Engine cross member 10mm. 8.5 mm. Damping to partition wall rearwall. 8.5 mm. Lining to backrest. 8.5 mm. Tunnel,front. 8.5 mm. At covering. 8.5 mm. To plug the mounting holes in the engine support 10mm. 8.5 mm. Left. 8.5 mm.

At rear cross member. Cross member to rear axle 32,5 mm.

Panelling to floor.

Entrance water drain. Left side member,outside. Side member, bottom outside. Inside rear pillar 32 mm. Main floor,left and right 31 mm. Side panel water drain left 32 mm.

Holder on left A-pillar.

In floor below rear seat bench 40 mm. Main floor 40 mm.

Cable passage,partition panel,top left.

Cable passage,partition panel, bottom right.

Partition panel,left and right. Used for brake lines.

Torsion bar,front.